G3GM
Would you like to react to this message? Create an account in a few clicks or log in to continue.

G3GM 1973 to 1977 A-bodys. Chevelles, Monte Carlos, El Caminos, Laguna, 442, Cutlass, Malibu, GTO, LeMans, Century, Regal, Grand Am, Grand Prix, Sprint, Gran Sport, Can Am, Hurst-olds, and other 73-77 A-bodies


Front Coil Spring Isolators

2 posters

G3GM :: G3 Tech :: Chassis and Suspension

Go down

Front Coil Spring Isolators Empty Front Coil Spring Isolators

Post by 77mali Fri Aug 07, 2015 8:49 pm

Anyone use either of these?  

This Moog isolator looks like a good reproduction part (rubber).
http://www.summitracing.com/parts/mog-k160044

This one is from Energy Suspension...curious if anyone has any feed-back on this urethane part?
http://www.summitracing.com/parts/ens-3-6108r/overview/
77mali
77mali
Donating Member
Donating Member

Street Cred : 62

Back to top Go down

Front Coil Spring Isolators Empty Re: Front Coil Spring Isolators

Post by Joe73 Fri Aug 07, 2015 8:51 pm

I have the moog rubber on the rears. No isolators on the fronts. Also when installing the rear springs, the top pig tail ends are supposed to point towards the centerline of the car. Found that tidbit of info in my assembly manual. Never new that.
Joe73
Joe73
Donating Member
Donating Member

Street Cred : 83

Back to top Go down

Front Coil Spring Isolators Empty Re: Front Coil Spring Isolators

Post by 77mali Fri Aug 07, 2015 8:58 pm

I had isolators on both front springs (look the same as the Moog part # above).
77mali
77mali
Donating Member
Donating Member

Street Cred : 62

Back to top Go down

Front Coil Spring Isolators Empty Re: Front Coil Spring Isolators

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

G3GM :: G3 Tech :: Chassis and Suspension

 
Permissions in this forum:
You cannot reply to topics in this forum