Advice on selling my engine/trany
3 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
Advice on selling my engine/trany
I’m looking for some advice on selling my engine/trany. I have a friend that wants just the engine and not the transmission. Below is a list of what the engine has for the basic block set up. I added the intake carb Edelbrock 750 electric choke, gear reduction starter and distributor HEI. The tranny was a From Jegs and is a TH 350 I paid 727.99 for it and it has a pro torque Converter I paid 788.99 to have made for the setup.
The whole set up has less than 8000 miles on it.
My question’s are would you separate them?
What would be a fair price for each?
If sold as a whole unit what is a fair price for that?
" />
" />
" />
The whole set up has less than 8000 miles on it.
My question’s are would you separate them?
What would be a fair price for each?
If sold as a whole unit what is a fair price for that?
" />
" />
" />
Wallyuph- Donating Member
- Street Cred : 31
Re: Advice on selling my engine/trany
I've had luck on both Craig's List and eBay. A couple years ago, I sold a 330HP 350 GM crate motor for $1200, but I didn't sell the AC Compressor, Alt, P/S, fuel pump or dist with it. Going to take the right buyer to purchase both I would imagine, but I don't see why you can't close to 5K for the set up.
74Malibu383- Donating Member
- Street Cred : 26
Re: Advice on selling my engine/trany
If it were still in a car, I'd be more hesitant to split them up since you could prove that both of them work. Being out of the car, I think it would be easier to sell a $1,xxx trans and a $3,500 engine than it would be to sell a $5000 combo.
Brainstain- Donating Member
- Street Cred : 8
Similar topics
» triple gauge kit - any advice?
» Need advice from those that lowered
» Thinking about selling.. feeler...
» Need advice from those that lowered
» Thinking about selling.. feeler...
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 12:58 pm by Keith Seymore
» Roll Call and Car showcase
Yesterday at 10:20 am by g3chevy / Mr Pontiac
» Central Texas Noob
Yesterday at 10:16 am by g3chevy / Mr Pontiac
» Welcome Keith Seymore
Yesterday at 10:03 am by g3chevy / Mr Pontiac
» Wanted: Front park lamp assemblies
Yesterday at 9:57 am by g3chevy / Mr Pontiac
» 75 Hurst Olds T-tpos
Yesterday at 9:44 am by g3chevy / Mr Pontiac
» G3 Chevy rims- help ID these
Tue Oct 29, 2024 8:26 pm by Limey SE
» 75 el camino project.
Mon Oct 28, 2024 12:03 pm by zucchi
» Have had a few questions
Sun Oct 27, 2024 12:04 pm by Limey SE
» vinyl top removal
Sat Oct 26, 2024 11:30 pm by 76Chevelle2Tone