Cam Bearing Tool
3 posters
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Cam Bearing Tool
I just bought a cam bearing install/remove tool, off ebay. Here is the link http://www.ebay.com/itm/380465586090?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
I have to say its pretty well made. I just removed my cam bearings in just a couple of minutes. I know it does small block chevys and I believe V6's as well. No mention of doing other brand engines. No instructions were included with the tool but its real simple to figure out. There's also youtube videos that show you have to do it.
So if anyone is interested in doing their own bearings, this tool is worth it. Especially for only $34 delivered.
Ant7377, your more than welcome to borrow it anytime.
I have to say its pretty well made. I just removed my cam bearings in just a couple of minutes. I know it does small block chevys and I believe V6's as well. No mention of doing other brand engines. No instructions were included with the tool but its real simple to figure out. There's also youtube videos that show you have to do it.
So if anyone is interested in doing their own bearings, this tool is worth it. Especially for only $34 delivered.
Ant7377, your more than welcome to borrow it anytime.
Joe73- Donating Member
- Street Cred : 83
Re: Cam Bearing Tool
Hey Joe ! That was a decent price.
Over the years I made my own parts for mine, to do Pontiacs, Cadillacs, Hemi Chryslers etc, to fit the original tool.
Over the years I made my own parts for mine, to do Pontiacs, Cadillacs, Hemi Chryslers etc, to fit the original tool.
pila- Donating Member
- Street Cred : 43
Re: Cam Bearing Tool
Cool. Good tool to have. I'm looking for a bore gauge if anyone is selling one cheap. I'd even take a harbor freight one but they dont make them anymore.
Joe73- Donating Member
- Street Cred : 83
Similar topics
» Tool boxes rolling tool chests snap on
» Harmonic Balancer Install Tool
» valve seals what tool to use
» Harmonic Balancer Install Tool
» valve seals what tool to use
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Today at 12:58 pm by Keith Seymore
» Roll Call and Car showcase
Today at 10:20 am by g3chevy / Mr Pontiac
» Central Texas Noob
Today at 10:16 am by g3chevy / Mr Pontiac
» Welcome Keith Seymore
Today at 10:03 am by g3chevy / Mr Pontiac
» Wanted: Front park lamp assemblies
Today at 9:57 am by g3chevy / Mr Pontiac
» 75 Hurst Olds T-tpos
Today at 9:44 am by g3chevy / Mr Pontiac
» G3 Chevy rims- help ID these
Tue Oct 29, 2024 8:26 pm by Limey SE
» 75 el camino project.
Mon Oct 28, 2024 12:03 pm by zucchi
» Have had a few questions
Sun Oct 27, 2024 12:04 pm by Limey SE
» vinyl top removal
Sat Oct 26, 2024 11:30 pm by 76Chevelle2Tone