engine problems
3 posters
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
engine problems
Since I've been fooling with the Caddy engine in my '75 Elco, it hasn't run very good. Lots of stuff checked while trying to get it to spool up over about 3,000 RPM. Ran rough & crapped out around 3,000....
Today I was driving it around on the airport & stopped to see a friend who was working on an airplane. When he heard how it was acting, he said to turn the top on the air cleaner up-side-down. So I did....
The engine immediately came alive, tire smoke & all !
He figured that the dish in the top cover plate of the stock Caddy air cleaner was partially blocking the vent tube that sits a bit above the the top of the Q-jet carb. He must have been correct !!
Don't know why it didn't bother when this engine was in the Coupe DeVille ! Weird...
Today I was driving it around on the airport & stopped to see a friend who was working on an airplane. When he heard how it was acting, he said to turn the top on the air cleaner up-side-down. So I did....
The engine immediately came alive, tire smoke & all !
He figured that the dish in the top cover plate of the stock Caddy air cleaner was partially blocking the vent tube that sits a bit above the the top of the Q-jet carb. He must have been correct !!
Don't know why it didn't bother when this engine was in the Coupe DeVille ! Weird...
pila- Donating Member
- Street Cred : 43
Re: engine problems
That is strange. So the lid is formed so the middle dips down or something?
bigredlaguna- G3GM Senior Member
- Street Cred : 53
Re: engine problems
The carbs used on the caddy engines had a different lower profile top air horn. The quadrajets have a taller profile with taller vent tubes. Also have to make sure the base of the air cleaner doesn't impede the operation of the accelerator pump arm. Sometimes all you need is a half inch tall spacer on the top of the carb.
chevellelaguna- G3GM Enthusiast
- Street Cred : 16
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Today at 12:58 pm by Keith Seymore
» Roll Call and Car showcase
Today at 10:20 am by g3chevy / Mr Pontiac
» Central Texas Noob
Today at 10:16 am by g3chevy / Mr Pontiac
» Welcome Keith Seymore
Today at 10:03 am by g3chevy / Mr Pontiac
» Wanted: Front park lamp assemblies
Today at 9:57 am by g3chevy / Mr Pontiac
» 75 Hurst Olds T-tpos
Today at 9:44 am by g3chevy / Mr Pontiac
» G3 Chevy rims- help ID these
Tue Oct 29, 2024 8:26 pm by Limey SE
» 75 el camino project.
Mon Oct 28, 2024 12:03 pm by zucchi
» Have had a few questions
Sun Oct 27, 2024 12:04 pm by Limey SE
» vinyl top removal
Sat Oct 26, 2024 11:30 pm by 76Chevelle2Tone