G3GM
Would you like to react to this message? Create an account in a few clicks or log in to continue.

G3GM 1973 to 1977 A-bodys. Chevelles, Monte Carlos, El Caminos, Laguna, 442, Cutlass, Malibu, GTO, LeMans, Century, Regal, Grand Am, Grand Prix, Sprint, Gran Sport, Can Am, Hurst-olds, and other 73-77 A-bodies


Replacing Turn Signal Switch

4 posters

G3GM :: G3 Tech :: Electrical

Go down

Replacing Turn Signal Switch Empty Replacing Turn Signal Switch

Post by Mcarlo77 Tue May 26, 2015 8:22 pm

Is it really possible to change a turn signal switch by feeding the wiring connector through the column? I watched a YouTube video where a guy had a mid-70's Vega GT and he was able to both remove the old one and install the new one without cutting the wires. I was under the impression it was too tight in there and it was necessary to cut the wires on the replacement switch, feed them through and then splice at the plug connector.
Mcarlo77
Mcarlo77
Donating Member
Donating Member

Street Cred : 78

Back to top Go down

Replacing Turn Signal Switch Empty Re: Replacing Turn Signal Switch

Post by Joe73 Tue May 26, 2015 8:47 pm

Yes, you can change the switch with cam plate without cutting anything. The harness with the long, flat plug slides right down the column. Actually a pretty easy job. I did it on my 73 back in the 80's. And then on a 79 regal. No problems.
Joe73
Joe73
Donating Member
Donating Member

Street Cred : 83

Back to top Go down

Replacing Turn Signal Switch Empty Re: Replacing Turn Signal Switch

Post by pila Wed May 27, 2015 9:58 pm

I changed one by pulling a piece of safety wire in while pulling the old one out, to get the new one pulled back in...
The " harmonica" connector will slide through OK...

pila
Donating Member
Donating Member

Street Cred : 43

Back to top Go down

Replacing Turn Signal Switch Empty Re: Replacing Turn Signal Switch

Post by Mcarlo77 Thu May 28, 2015 6:37 pm

Thanks for confirming that it can be done. Really didn't want spliced wires.
Mcarlo77
Mcarlo77
Donating Member
Donating Member

Street Cred : 78

Back to top Go down

Replacing Turn Signal Switch Empty Re: Replacing Turn Signal Switch

Post by 1973montec Mon Jun 01, 2015 11:16 am

you can pluck the wires out of each connector with a paper clip. slide it through and put pins back in connector.
1973montec
1973montec
Donating Member
Donating Member

Street Cred : 17

Back to top Go down

Replacing Turn Signal Switch Empty Re: Replacing Turn Signal Switch

Post by Mcarlo77 Mon Jun 01, 2015 3:23 pm

Good point. Always nice to have a Plan B in case the harmonica plug won't cooperate.
Mcarlo77
Mcarlo77
Donating Member
Donating Member

Street Cred : 78

Back to top Go down

Replacing Turn Signal Switch Empty Re: Replacing Turn Signal Switch

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

G3GM :: G3 Tech :: Electrical

 
Permissions in this forum:
You cannot reply to topics in this forum