i need help again!
3 posters
G3GM :: G3 Tech :: Electrical
Page 1 of 1
i need help again!
im having problems with my car. it wont start
ive narrowed it down to either ignition module or pick up coil.
what happened is that it was running great went to start it up 6 or 7 hours later and it turns over but doesnt get any spark. for a while now it has been giving me problems starting up when its cold or the weather changes from hot to cold when theres a lot of moisture. all i had to do when that happened was puul a plug out and it would fire right up. let it run for about 30 seconds hop out put the plug back in and it ran great. now i cant get it to start at all. i noticed that when it has this problem that the spark was weak to the plug on initial cranking. any ideas and help would be of great help. i dont have an ohm or volt meter because if i did i'd be ordering parts already.
ive narrowed it down to either ignition module or pick up coil.
what happened is that it was running great went to start it up 6 or 7 hours later and it turns over but doesnt get any spark. for a while now it has been giving me problems starting up when its cold or the weather changes from hot to cold when theres a lot of moisture. all i had to do when that happened was puul a plug out and it would fire right up. let it run for about 30 seconds hop out put the plug back in and it ran great. now i cant get it to start at all. i noticed that when it has this problem that the spark was weak to the plug on initial cranking. any ideas and help would be of great help. i dont have an ohm or volt meter because if i did i'd be ordering parts already.
McCauley5983- G3GM Enthusiast
- Street Cred : 14
Re: i need help again!
Something to look at as well is the distributor rotor. The factory ones were notorious for failure, although by now it should have been changed out anyways. I recall someone once calling them the "dreaded black bugs".
I could give a few more things to look at, but here is some information on Team Chevelle that should help:
http://www.chevelles.com/techref/ftecref5.html
I could give a few more things to look at, but here is some information on Team Chevelle that should help:
http://www.chevelles.com/techref/ftecref5.html
The Dude- Management
- Street Cred : 48
Re: i need help again!
i put an msd coil cap and rotor on it already borrowed an ohm meter and found out my pick up coil is shot. go figure
McCauley5983- G3GM Enthusiast
- Street Cred : 14
Re: i need help again!
just step to the Better mallory ignition the high voltage type and never have a prob again
___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE- Management
- Street Cred : 98
G3GM :: G3 Tech :: Electrical
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Today at 12:58 pm by Keith Seymore
» Roll Call and Car showcase
Today at 10:20 am by g3chevy / Mr Pontiac
» Central Texas Noob
Today at 10:16 am by g3chevy / Mr Pontiac
» Welcome Keith Seymore
Today at 10:03 am by g3chevy / Mr Pontiac
» Wanted: Front park lamp assemblies
Today at 9:57 am by g3chevy / Mr Pontiac
» 75 Hurst Olds T-tpos
Today at 9:44 am by g3chevy / Mr Pontiac
» G3 Chevy rims- help ID these
Tue Oct 29, 2024 8:26 pm by Limey SE
» 75 el camino project.
Mon Oct 28, 2024 12:03 pm by zucchi
» Have had a few questions
Sun Oct 27, 2024 12:04 pm by Limey SE
» vinyl top removal
Sat Oct 26, 2024 11:30 pm by 76Chevelle2Tone