EGR
+2
Joe73
lars
6 posters
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
EGR
Do our cars have egr valves? I know it was invented in the 70's, but I'm unaware if it was in common use yet, and if I should be thinking about replacing it.
lars- G3GM Member
- Street Cred : 2
Re: EGR
If your engine is original to the car- yes. They are located on the intake manifold it's the "Exhaust Gas Recirculator". There will be a vacuum line going in to it and it has a cast iron mounting plate under it & a gasket bolted as a unit to the intake w/ 2 bolts. Might be obscured by the air cleaner, although it's usually mounted towards the front on the passenger side. They're about $40-50.00. You might be able to clean it out by adding a can of "Seafoam" to your gas tank. That will also clean out your air intake cross-over chambers, which tend to get gunky over time (but that's normal).
77mali- Donating Member
- Street Cred : 62
Re: EGR
77mali wrote:
The item circled in this pic is a heater valve. The EGR valve can't be seen in this pic, it would be underneath the air cleaner on the passenger side of the carburetor.
bigredlaguna- G3GM Senior Member
- Street Cred : 53
Re: EGR
+1 on the heater control valve.
They kinda look the same but the EGR sits on the intake manifold and has a larger tube to the carb,the heater control uses a small vacuum line.
The EGR should be left alone.
They tend to leak once removed.
No performance to be gained by changing it out.
They kinda look the same but the EGR sits on the intake manifold and has a larger tube to the carb,the heater control uses a small vacuum line.
The EGR should be left alone.
They tend to leak once removed.
No performance to be gained by changing it out.
Sinister- G3GM Member
- Street Cred : 0
Re: EGR
My bad guys- looked at the pic again & it's def...wrong. Sorry Lars but at least you get the idea now.
77mali- Donating Member
- Street Cred : 62
Re: EGR
Cap it off. On both ends ,shove a Bearing in the vacuum hose if you want the effect.
ant7377- G3GM Addict
- Street Cred : 36
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Today at 12:58 pm by Keith Seymore
» Roll Call and Car showcase
Today at 10:20 am by g3chevy / Mr Pontiac
» Central Texas Noob
Today at 10:16 am by g3chevy / Mr Pontiac
» Welcome Keith Seymore
Today at 10:03 am by g3chevy / Mr Pontiac
» Wanted: Front park lamp assemblies
Today at 9:57 am by g3chevy / Mr Pontiac
» 75 Hurst Olds T-tpos
Today at 9:44 am by g3chevy / Mr Pontiac
» G3 Chevy rims- help ID these
Tue Oct 29, 2024 8:26 pm by Limey SE
» 75 el camino project.
Mon Oct 28, 2024 12:03 pm by zucchi
» Have had a few questions
Sun Oct 27, 2024 12:04 pm by Limey SE
» vinyl top removal
Sat Oct 26, 2024 11:30 pm by 76Chevelle2Tone