What u-joints are you using

by JF74chevelle Sat May 11, 2019 12:47 pm

I bought some Moog replacement U-joints but they don’t fit. Since I had to melt out the plastic from the stock ones I had to buy new ones because the old ones were shot. But now the new ones have the two inner snap rings to go in but if I get one side in then the other side is sticking out.

These are what I bought but don’t seem to fit. https://www.moog-suspension-parts.com/moog-ujoint-packagedeal842

I think I need these https://www.ecklerschevelle.com/chevelle-and-malibu-drive-shaft-universal-joint-with-oututside-lock-up-rings-front-or-rear-1973-1983.html

by bigredlaguna Sat May 11, 2019 1:16 pm

Caps sticking out too far usually indicates that some of the needles came loose and are in the ends of the caps. Did you remove the caps and make sure the needles are where they are supposed to be?

by JF74chevelle Sat May 11, 2019 1:28 pm

bigredlaguna wrote:Caps sticking out too far usually indicates that some of the needles came loose and are in the ends of the caps. Did you remove the caps and make sure the needles are where they are supposed to be?

That’s a possibility, I’ll check when I get home from work tonight. Thank you

by bracketchev1221 Sun May 12, 2019 7:56 pm

I use the spicer joints. Not sure who makes moog joints but a lot of them are just reboxed.

by Sponsored content

What u-joints are you using

What u-joints are you using

Re: What u-joints are you using

Re: What u-joints are you using

Re: What u-joints are you using

Re: What u-joints are you using