Posi done!
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Posi done!
by ant7377 Sun Aug 02, 2009 11:55 am
I just installed my Auburn carrier yesterday.Went smoothly and the car feels great!
Just FYI the rear I have dosent use C-clips its the BOP rear with bolt in axles from the factory
this was in my car from new (77 Monte) the bearings and carrier are all the same-(OTHER THAN
THE AXLE BEARINGS) as a chevy diff 8.5 ten bolt with c-clips. So if you have one of these
you just need the right axle bearings and seals and the bearings and seal need to be pressed on
the new ones also look a little different than the originals but work fine.
Just FYI the rear I have dosent use C-clips its the BOP rear with bolt in axles from the factory
this was in my car from new (77 Monte) the bearings and carrier are all the same-(OTHER THAN
THE AXLE BEARINGS) as a chevy diff 8.5 ten bolt with c-clips. So if you have one of these
you just need the right axle bearings and seals and the bearings and seal need to be pressed on
the new ones also look a little different than the originals but work fine.
ant7377- G3GM Addict
- Street Cred : 36
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
» Stroh's Fabrication Bucket Seat/Console Brackets - Review
» 74 Elcamino project
» Dual exhaust for 75 fourdoor
» 1973 Chevelle SS shifter knob
» Grand Lemans - SoCal - $800
» G3GM Decals/stickers Now Available for purchase.
» G3 Cars at Mecum Kissimmee
» Hey Zucchi
» Need radio help