New guy here from Florida
+17
77mali
thatfnthing
1973 454 MONTE
Bruisr
Joe73
Limey SE
dragons_lair59
skeezix91
driveit
Laguna Budman
JB2wheeler
ant7377
jurgenday
bigredlaguna
1973montec
Pontichev327
Tom77
21 posters
G3GM :: Media :: G3 Project Pictures
Page 11 of 11
Page 11 of 11 • 1, 2, 3 ... 9, 10, 11
Re: New guy here from Florida
thanks will do, now i wanna find the laguna nose and keep the laguna look to it, sucks there isnt any down here :/
thepossumface- G3GM Member
- Street Cred : 1
Re: New guy here from Florida
Well most of the car is stripped and so forth of interior except my seats which are going to be sold here in the next few weeks, gonna sand blast the whole inside weld the sheet metal to the floors so no more rust holes, and start on redoing the interior while we wait on the motor to be fixed im debating on to fix what I have in there or buy a new 454 motor and put in fuel injection on it,
any thoughts or ideas if anyone else has done a Efi swap? im prob going to rip all the wiring out and put a painless wire harness in it and redo all the wires so I know this isnt half assed
any thoughts or ideas if anyone else has done a Efi swap? im prob going to rip all the wiring out and put a painless wire harness in it and redo all the wires so I know this isnt half assed
thepossumface- G3GM Member
- Street Cred : 1
Re: New guy here from Florida
There are a few nice EFI systems out there, but they are a bit pricey for me. I think they are around $2000 on the average. Holley makes a good one from what I've read about tests on it. I've thought about doing the same with the wiring on my 75 Chevelle too. Underdash is a bit messy with some cut wires. Good luck on getting it squared away, and I look forward to seeing pictures of your progress. Maybe you should make a build thread.
Bill
Bill
WyldeBill66- G3GM Member
- Street Cred : 3
Re: New guy here from Florida
i think i will do that once i get a computer and camera up again, ive read about the holly efi thing in a article one day and sounds very good to have but right now im seeing on what i can work with and figure out the wiring out after words, i love my carb's but id like to see what the car will push with the EFI system and then later upgrade to a weland super charger. but thats just what I would like to do in the future with it.
thepossumface- G3GM Member
- Street Cred : 1
Re: New guy here from Florida
Can anyone tell me how much the rear bumber would cost? i got a guy who wants it but idk what they would go for, maybe 100?
thepossumface- G3GM Member
- Street Cred : 1
Re: New guy here from Florida
That's the going rate from the salvage yards around me (except the Pick 'N Pulls...where they're considerably cheaper).
Mcarlo77- Donating Member
- Street Cred : 78
Re: New guy here from Florida
Probably about $150.00. More or less depending on condition.
dynchel- Donating Member
- Street Cred : 40
Page 11 of 11 • 1, 2, 3 ... 9, 10, 11
G3GM :: Media :: G3 Project Pictures
Page 11 of 11
Permissions in this forum:
You cannot reply to topics in this forum
Today at 3:23 am by 76Chevelle2Tone
» Dual exhaust for 75 fourdoor
Today at 12:49 am by relic7680
» Monte Carlo -75
Thu Jan 23, 2025 2:19 pm by Finn Monte
» Life & Back On The Radio
Mon Jan 20, 2025 3:36 pm by knightfan26917
» 74 Elcamino project
Sat Jan 18, 2025 5:09 pm by gman
» 1973 Chevelle Parts For Sale - Steering Wheel and Column
Fri Jan 17, 2025 7:58 pm by 76 Malibu
» Stroh's Fabrication Bucket Seat/Console Brackets - Review
Fri Jan 17, 2025 7:57 pm by 76 Malibu
» 1973 Chevelle SS shifter knob
Wed Jan 15, 2025 9:19 am by Mitchell Murphy
» Grand Lemans - SoCal - $800
Tue Jan 14, 2025 11:34 pm by g3chevy / Mr Pontiac
» G3GM Decals/stickers Now Available for purchase.
Sun Jan 12, 2025 5:07 pm by Limey SE