G3GM
Would you like to react to this message? Create an account in a few clicks or log in to continue.

G3GM 1973 to 1977 A-bodys. Chevelles, Monte Carlos, El Caminos, Laguna, 442, Cutlass, Malibu, GTO, LeMans, Century, Regal, Grand Am, Grand Prix, Sprint, Gran Sport, Can Am, Hurst-olds, and other 73-77 A-bodies


Power Trunk Solenoid Release Install

2 posters

G3GM :: G3 Tech :: Body

Go down

Power Trunk Solenoid Release Install Empty Power Trunk Solenoid Release Install

Post by Hawk03 Sun Dec 29, 2019 8:11 pm

I thought installing a factory trunk solenoid would be easy but I should know better by now. Do I need to cut some sheet metal to make the trunk release work? The solenoid itself installs fine but the flipper? rests on the V cut out (left of the lock shaft) and cannot move to the left when activated to push the lever to unlock the trunk. Am I installing it correctly? It seems like it can only go on one way though. Are the trunk locks different on certain years? This is on a 1977.

Power Trunk Solenoid Release Install 20191213
Power Trunk Solenoid Release Install 20191212
Hawk03
Hawk03
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 18

Back to top Go down

Power Trunk Solenoid Release Install Empty Re: Power Trunk Solenoid Release Install

Post by Mcarlo77 Sun Dec 29, 2019 9:29 pm

Yes...you may need to grind off a little sheet metal so that "flipper" rod can move freely. I had forgotten about needing to do that. Think I used my Dremel with a grinding wheel bit and it didn't take much. I know that probably doesn't sit well with a freshly painted trunk lid...but, just put some touch-up paint on it and you'll be good.
Mcarlo77
Mcarlo77
Donating Member
Donating Member

Street Cred : 78

Back to top Go down

Power Trunk Solenoid Release Install Empty Re: Power Trunk Solenoid Release Install

Post by Hawk03 Sun Dec 29, 2019 11:37 pm

Thanks Steve! Before I cut too much off and have a bigger issue I wanted to make sure that cutting some metal is what was needed. I'll go slow and touch it up as needed.
Hawk03
Hawk03
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 18

Back to top Go down

Power Trunk Solenoid Release Install Empty Re: Power Trunk Solenoid Release Install

Post by Hawk03 Mon Dec 30, 2019 11:02 am

Below is what I cut out and the trunk release works!

Power Trunk Solenoid Release Install 20191214
Hawk03
Hawk03
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 18

Back to top Go down

Power Trunk Solenoid Release Install Empty Re: Power Trunk Solenoid Release Install

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

G3GM :: G3 Tech :: Body

 
Permissions in this forum:
You cannot reply to topics in this forum