Rocker molding mounting
2 posters
Rocker molding mounting
by lars Sun Jun 24, 2018 12:41 pm
Hello,
Just installed a new fender but I don't know how to attach the rocker molding.
The fender already has these metal brackets on it:
I can either get the top or the bottom in, but not both.
This is the back of the molding:
Just installed a new fender but I don't know how to attach the rocker molding.
The fender already has these metal brackets on it:
I can either get the top or the bottom in, but not both.
This is the back of the molding:
lars- G3GM Member
- Street Cred : 2
Re: Rocker molding mounting
by g3chevy / Mr Pontiac Sun Jun 24, 2018 1:51 pm
Those brackets on the fender have nuts on the inside of the fender. You'll need to remove those and install the brackets inside the grooves of the fender molding. You can see where there are tabs machined into the back side of the molding that will need to be bent out a little bit to install the brackets. Then bend them back down to secure them properly. Then insert the studs into the existing holes in the fender and replace the nuts on the inside and snug everything up. Then you should be good to go.
g3chevy / Mr Pontiac- Donating Member
- Street Cred : 35
Re: Rocker molding mounting
by g3chevy / Mr Pontiac Sun Jun 24, 2018 1:56 pm
Should look something like this.
g3chevy / Mr Pontiac- Donating Member
- Street Cred : 35
Similar topicsPermissions in this forum:
You cannot reply to topics in this forum
» 1973 Chevelle Parts For Sale - Steering Wheel and Column
» Stroh's Fabrication Bucket Seat/Console Brackets - Review
» Dual exhaust for 75 fourdoor
» 1973 Chevelle SS shifter knob
» Grand Lemans - SoCal - $800
» G3GM Decals/stickers Now Available for purchase.
» G3 Cars at Mecum Kissimmee
» Hey Zucchi
» Need radio help